Views: 0 Author: Site Editor Publish Time: 2023-01-11 Origin: Site
The Caulking Gun is a simple mechanical device that uses the principle of leverage. It is used in conjunction with a glue bucket or glue stick to easily push the glue in the glue bucket out of the tip, greatly saving the operating time. The glue gun is a tool for gluing, sealing, sealing and gluing. It is widely used in architectural decoration, electronic equipment, automobiles and auto parts, ships and containers and other industries.
What are the precautions for the operation of the Caulking Gun?
What is the tip for using the Caulking Gun?
What are the installation tips for the Caulking Gun?
1. The air pressure connected to the Caulking Gun should not exceed 145 psi.
2.Before disassembling the glue gun, the compressed air line must be disconnected.
3.For smooth operation, apply the solvent recommended by the sealant manufacturer after each application to wipe the remaining sealant in the cylinder. (The glue gun must not be immersed in solvent)
4.During construction, the front end of the barrel should often be tightly closed.
5.After the Caulking Gun is finished, please handle the glue gun carefully and be sure to damage the front cover and rear silencer.
6. Do not point weapons at persons.
7.When working continuously, the glue gun should not stop working for more than five minutes. Otherwise, it should be glued until the glue has leaked.
8.The high pressure hose must not be forcibly squeezed or bent to prevent the normal operation of the glue gun from being affected.
1.The most important thing is to hold the trigger of the Caulking Gun with the right hand, and the force for extruding the glass glue must be uniform. To use what we normally call "yin power," that is to maintain a certain amount of strength, but not from large to small. The most important point is to do it at once, not to press, stop and stop, otherwise the glass glue will become intermittent or large and small. Because usually, when the glass glue is pressed straight out of the nozzle, it is a relatively large spherical shape. If the pieces are large and small, you can smooth them later only with the wiping method.
2.Control the opening of the Caulking Gun with your left hand and make sure that the beveled opening of the opening is close to the gap and cannot be shaken.
3.The steps should be calm, the movement distance should be calibrated in advance, and the steps should not be moved too much if possible, and the legs should be slightly apart to ensure that the upper body is translated or the waist is turned and with the hands the glass glue is pressed out. straight line. If the steps move too much, this inevitably affects the stability of the extruded glass adhesive.
First, with a tool, insert a hole in the rubber head and the rubber tail iron cover, and after removing the cover, screw the rubber nozzle through the rubber head and thread it onto the rubber head, so that the fastening ring can be attached to the end of the glue gun;
Then press with one hand on the spring of the glue gun, turn the extension arm upwards with the other hand and slowly insert it from the tail into the glue gun.
Finally, place the head of the glue gun on the mounting ring. If it cannot be pressed, simply press the switch of the glue gun.
SAAME Tools has been focusing on the development and production of Caulking Guns for several years. And it is committed to providing perfect service to every customer from all over the world.
Home | Products | About KENDO | Distribution Network | Events | Contact Us